The L298N Dual H-bridge Stepper Motor Driver Controller Board, using ST L298N chip can directly drive two 3-30V DC motor, and provides a 5V output interface, you can chip circuitry to 5V power supply, support 3.3VMCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper motor, smart car essential.Ĭontrol signals are connected to popular goldpin connectors, allowing to connect the circuit to run boards, such as Arduino, using wires. Screw terminals allow for easy connection of the motor(s) and the power supply. It includes an optional on-board 5V regulator for powering its internal logic circuit so only one supply voltage is required (Vm = 6 to 12V). Alternatively, the module is capable of driving a single 4 input stepper motor. This L298N Dual H-bridge allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino. The L298N Dual H-bridge Stepper Motor Driver Controller Board contains a dual channel full H-bridge driver. This module USES L298N as the main drive chip, with strong driving ability, low heat and strong anti-interference ability. There is also an onboard 5V regulator, so if your supply voltage is up to 12V you can also source 5V from the board. The L298N Dual H-bridge Stepper Motor Driver Controller Board can be used with motors that have a voltage of between 5 and 35V DC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |